UNMOUNTABLE_BOOT_VOLUME Error Message
May 25, 2010, (1,629 views) | in Hard Disk Repair | 2 Comments
After installing or upgrading Windows XP from Windows 95 or 98 an error message:
STOP 0x000000ED (0x aaaaaaaa ,0x bbbbbbbb ,0x cccccccc ,0x dddddddd ) UNMOUNTABLE_BOOT_VOLUME appears when Windows tries to load.
This error is generated by design through Microsoft to prevent any data loss during operation. By design this error can incur when:
- A 40-wire cable is used to connect an Ultra ATA hard drive to an Ultra ATA hard disk controller.
- Improper BIOS settings
- A file system may be damaged and cannot be mounted.
To resolve this issue:
- Replace the 40-wire cable with an 80-wire Ultra ATA Cable
- In the BIOS load the "Fail Safe Default Settings".
- Restart the computer. If it doesn’t correct the problem a file system may be damaged.
Repairing a Damaged File System
- Restart the computer with the XP install disk.
- Press R to select the Repair Option at the "Welcome to Setup" screen.
- Enter administrator password if prompted to do so.
- At the next prompt press 1 and Enter .
- This should bring you to the command prompt "C:" or "C:Windows".
- Type chkdsk /r and press enter. This will scan the disk and repair any errors.
- Type fixboot X: where "X" is the drive that you are installing the operating system on.
- Restart the system. If Windows still errors repeat steps 1 thru 5.
- Type fixmbr at the command prompt.
If all the above steps fail you may run a low-level format on the drive using SeaTools. Run the Write Disk Pack. This process may take several hours depending on the size of the drive.
